국내 최대 기계 및 로봇 연구정보

기술보고서

기술보고서 게시판 내용
타이틀	Temperature and Atomic Oxygen Effects on Helium Leak Rates of a Candidate Main Interface Seal
저자	Penney, Nicholas;; Wasowski, Janice L.;; Daniels, Christopher C.
Keyword	EXPOSURE;; FLOW VELOCITY;; HELIUM;; LEAKAGE;; MOLECULAR FLOW;; NASA PROGRAMS;; OXYGEN;; OXYGEN ATOMS;; SPACECRAFT DOCKING;; TEMPERATURE EFFECTS;; VACUUM;; VISCOUS FLOW
URL	http://hdl.handle.net/2060/20110005656
보고서번호	NASA/CR-2011-216830
발행년도	2011
출처	NTRS (NASA Technical Report Server)
ABSTRACT	Helium leak tests were completed to characterize the leak rate of a 54 in. diameter composite space docking seal design in support of the National Aeronautics and Space Administration s (NASA''s) Low Impact Docking System (LIDS). The evaluated seal design was a candidate for the main interface seal on the LIDS, which would be compressed between two vehicles, while docked, to prevent the escape of breathable air from the vehicles and into the vacuum of space. Leak tests completed at nominal temperatures of -30, 20, and 50 C on untreated and atomic oxygen (AO) exposed test samples were examined to determine the influence of both test temperature and AO exposure on the performance of the composite seal assembly. Results obtained for untreated seal samples showed leak rates which increased with increased test temperature. This general trend was not observed in tests of the AO exposed specimens. Initial examination of collected test data suggested that AO exposure resulted in higher helium leak rates, however, further analysis showed that the differences observed in the 20 and 50 C tests between the untreated and AO exposed samples were within the experimental error of the test method. Lack of discernable trends in the test data prevented concrete conclusions about the effects of test temperature and AO exposure on helium leak rates of the candidate seal design from being drawn. To facilitate a comparison of the current test data with results from previous leak tests using air as the test fluid, helium leak rates were converted to air leak rates using standard conversion factors for viscous and molecular flow. Flow rates calculated using the viscous flow conversion factor were significantly higher than the experimental air leakage values, whereas values calculated using the molecular flow conversion factor were significantly lower than the experimentally obtained air leak rates. The difference in these sets of converted flow rates and their deviation from the experimentally obtained air leak rate data suggest that neither conversion factor can be used alone to accurately convert helium leak rates to equivalent air leak rates for the test seals evaluated in this study;; other leak phenomena, including permeation, must also be considered.